furnace/doc/7-systems/opll.md

Yamaha YM2413/OPLL

the YM2413, otherwise known as OPLL, is a cost-reduced FM synthesis sound chip, based on the Yamaha YM3812 (OPL2). thought OPL was downgraded enough? :p

OPLL also spawned a few derivative chips, the best known of these is:

• the famous Konami VRC7. used in the Japan-only video game Lagrange Point, it was another cost reduction on top of the OPLL! this time just 6 channels...
• Yamaha YM2423, same chip as YM2413, just a different patch set
• Yamaha YMF281, ditto

technical specifications

the YM2413 is equipped with the following features:

• 9 channels of 2 operator FM synthesis

• A drum/percussion mode, replacing the last 3 voices with 5 rhythm channels, with drum mode tones hard-defined in the chip itself, like FM instruments. Only pitch might be altered.

  • Drum mode works like following: FM channel 7 is for Kick Drum, which is a normal FM channel but routed through mxier twice for 2x volume, like all drum sounds. FM channel 8 splits to Snare Drum and Hi-Hat. Snare Drum is the carrier and it works with a special 1 bit noise generator combined with a square wave, all possible by overriding phase-generator with some different synthesis method. Hi-Hat is the modulator and it works with the noise generator and also the special synthesis. CH9 splits to Top-Cymbal and Tom-Tom, Top-Cymbal is the carrier and only has the special synthesis, while Tom-Tom is basically a 1op wave.
  • Special syntheis mentioned already is: 5 square waves are gathered from 4x, 64x and 128x the pitch of channel 8 and 16x and 64x the pitch of channel 9 and they go through a process where 2 HH bits OR'd together, then 1 HH and 1 TC bit OR'd, then the two TC bits OR'd together, and those 3 results get XOR'd.

• 1 user-definable patch (this patch can be changed throughout the course of the song)

• 15 pre-defined patches which can all be used at the same time

• Support for ADSR on both the modulator and the carrier

• Sine and half-sine based FM synthesis

• 9 octave note control

• 4096 different frequencies for channels

• 16 unique volume levels (NOTE: Volume 0 is NOT silent.)

• Modulator and carrier key scaling

• Built-in hardware vibrato support

effects

• 11xx: set feedback of channel.
• 12xx: set operator 1 level.
• 13xx: set operator 2 level.
• 16xy: set multiplier of operator.
  • x is the operator (1 or 2).
  • y is the multiplier.
• 18xx: toggle drums mode.
  • 0 disables it and 1 enables it.
  • only in drums chip.
• 19xx: set attack of all operators.
• 1Axx: set attack of operator 1.
• 1Bxx: set attack of operator 2.
• 50xy: set AM of operator.
  • x is the operator (1-2). a value of 0 means "all operators".
  • y determines whether AM is on.
• 51xy set SL of operator.
  • x is the operator (1-2). a value of 0 means "all operators".
  • y is the value.
• 52xy set RR of operator.
  • x is the operator (1-2). a value of 0 means "all operators".
  • y is the value.
• 53xy: set VIB of operator.
  • x is the operator (1-2). a value of 0 means "all operators".
  • y determines whether VIB is on.
• 54xy set KSL of operator.
  • x is the operator (1-2). a value of 0 means "all operators".
  • y is the value.
• 55xy set EGT of operator.
  • x is the operator (1-2). a value of 0 means "all operators".
  • y determines whether EGT is on.
• 56xx: set DR of all operators.
• 57xx: set DR of operator 1.
• 58xx: set DR of operator 2.
• 5Bxy: set KSR of operator.
  • x is the operator (1-2). a value of 0 means "all operators".
  • y determines whether KSR is on.