31 lines
1.3 KiB
Markdown
31 lines
1.3 KiB
Markdown
# X1-010 instrument editor
|
|
|
|
X1-010 instrument editor contains three tabs: Sample, Wavetable and Macros.
|
|
|
|
## Sample
|
|
|
|
for sample settings, see [the Sample instrument editor](sample.md).
|
|
|
|
the only differences are the lack of an "Use wavetable" option, and the presence of a "Use sample" one.
|
|
|
|
there also is a "Sample bank slot" setting, but I think that does nothing for now.
|
|
|
|
## Wavetable
|
|
|
|
this allows you to enable and configure the Furnace wavetable synthesizer. see [this page](wavesynth.md) for more information.
|
|
|
|
## Macros
|
|
|
|
- **Volume**: volume levels sequence.
|
|
- **Arpeggio**: pitch sequence.
|
|
- **Waveform**: waveform selection sequence.
|
|
- **Panning (left)**: output level for left channel.
|
|
- **Panning (right)**: output level for right channel.
|
|
- **Pitch**: fine pitch.
|
|
- **Envelope Mode**: sets up envelope. the way it works is kind of complicated and even I don't understand how it works, so it's not documented for now.
|
|
- **Envelope**: specifies which wavetable should be used for envelope.
|
|
- **AutoEnv Num**: sets the envelope to the channel's frequency multiplied by numerator.
|
|
- **AutoEnv Den**: sets the envelope to the channel's frequency divided by denominator.
|
|
- the X1-010 hardware envelope is considerably slower than AY's. beware!
|
|
- these two must be set in order for AutoEnv to work!
|