| 
									
										
										
										
											2023-09-10 00:11:43 -04:00
										 |  |  | # Ensoniq ES5506 instrument editor
 | 
					
						
							|  |  |  | 
 | 
					
						
							| 
									
										
										
										
											2023-09-10 13:16:55 -04:00
										 |  |  | the ES5506 instrument editor contains three tabs: Sample, ES5506 and Macros. | 
					
						
							| 
									
										
										
										
											2023-09-10 00:11:43 -04:00
										 |  |  | 
 | 
					
						
							|  |  |  | ## Sample
 | 
					
						
							|  |  |  | 
 | 
					
						
							|  |  |  | for sample settings, see [the Sample instrument editor](sample.md). | 
					
						
							|  |  |  | 
 | 
					
						
							|  |  |  | ## ES5506
 | 
					
						
							|  |  |  | 
 | 
					
						
							|  |  |  | ES5506 contains a filter, which is somewhat configurable. | 
					
						
							|  |  |  | there's also a hardware envelope, but it's probably most useful for smoothing. | 
					
						
							|  |  |  | 
 | 
					
						
							|  |  |  | you may use this tab to set up ES5506-specific parameters: | 
					
						
							|  |  |  | 
 | 
					
						
							|  |  |  | - **Filter Mode**: sets filter mode. | 
					
						
							|  |  |  |   - **HP/K2, HP/K2**: run high-pass twice using filter K2. | 
					
						
							|  |  |  |   - **HP/K2, LP/K1**: run high-pass using filter K2, and then low-pass using filter K1. | 
					
						
							|  |  |  |   - **LP/K2, LP/K2**: run low-pass twice using filter K2. | 
					
						
							|  |  |  |   - **LP/K2, LP/K1**: run low-pass using filter K2, and then again using filter K1. | 
					
						
							|  |  |  | - **Filter K1**: set coefficient 1 (K1). effectively controls cutoff. | 
					
						
							|  |  |  | - **Filter K2**: set coefficient 2 (K2). effectively controls cutoff. | 
					
						
							|  |  |  | - **Envelope count**: set length of hardware envelope (it's very short even at highest value). | 
					
						
							|  |  |  | - **Left Volume Ramp**: how much to change left volume on every envelope step. | 
					
						
							|  |  |  | - **Right Volume Ramp**: how much to change right volume on every envelope step. | 
					
						
							|  |  |  | - **Filter K1 Ramp**: how much to change filter K1 every envelope step. | 
					
						
							|  |  |  | - **Filter K2 Ramp**: how much to change filter K2 on every envelope step. | 
					
						
							|  |  |  | - **K1 Ramp Slowdown**: increases length of K1 ramp. | 
					
						
							|  |  |  | - **K2 Ramp Slowdown**: increases length of K2 ramp. | 
					
						
							|  |  |  | 
 | 
					
						
							|  |  |  | ## Macros
 | 
					
						
							|  |  |  | 
 | 
					
						
							|  |  |  | - **Volume**: volume sequence. | 
					
						
							|  |  |  | - **Arpeggio**: pitch sequence. | 
					
						
							|  |  |  | - **Filter Mode**: sets filter mode. | 
					
						
							|  |  |  | - **Panning (left)**: output level for left channel. | 
					
						
							|  |  |  | - **Panning (right)**: output level for right channel. | 
					
						
							|  |  |  | - **Pitch**: fine pitch. | 
					
						
							|  |  |  | - **Phase Reset**: trigger restart of waveform. | 
					
						
							|  |  |  | - **Filter K1**: K1 sequence. | 
					
						
							|  |  |  | - **Filter K2**: K2 sequence. | 
					
						
							|  |  |  | - **Outputs**: ES5506 has 6 stereo output (total 12). select which pair of outputs to use. | 
					
						
							|  |  |  | - **Control**: reverse/pause sequence. |